AmbiCoustic C+B (Cradle and Batten)
Acoustic UFH
Acoustic improvement 28 dB
35 mm + build up
Dry floor
Suited to correct uneven subfloors
AmbiCoustic C+B (Cradle and Batten) Underfloor Heating System Overview
- New build, refurbishment & conversion projects
- Concrete subfloors
- Timber subfloors
- Commercial installations, such as schools, sports floors and dance floors
- Gyms & free weight areas
AmbiCoustic Cradle and Batten enables quick and simple levelling of uneven subfloors through the use of 2 mm and 5 mm cradle packers positioned within the cradle legs and below the battens. Additional levelling can also be achieved with 10 mm and 30 mm cradle base packers.
No levelling screeds are required as AmbiCoustic can be placed directly on the subfloor and, as the cradles are loosely positioned on the subfloor, no fixings are required either. The versatility of the system also allows for a wide range of finished floor heights to be achieved and increased heights can be accomplished with the use of base packers.
This dry and lightweight solution also eliminates the need for wet trades, which significantly reduces preparation time and installation costs, as well as streamlining programming, on-site processes and reducing structural loadings.
AmbiCoustic C+B (Cradle and Batten) Downloads and Ordering
Get a Quick Quote
Get a quote
Request a Sample
AmbiCoustic C+B (Cradle and Batten) Specification
System Type Plated
Sub Floor Solid
Pipe size (mm) 17x2mm
Panel size (mm) N/A
Pipe Centres (mm) 150, 200
Minimum Build up excluding floor finish 0.5mm
Based on 0 tog, 45 degree MWT and 20 degree room temp output (W/m2) 76
Weight (kg/m2) 3.1 + weight of cradle and batten components
Acoustic Improvement (dB) Refer to acoustic specification of cradle and batten
Dependant on pipe centres max m2 per loop 24
Heat Pump Ready Yes
What’s included in the AmbiCoustic C+B (Cradle and Batten) system
Manifold
Depends on heated area – normally approx 1 port per 20 m2 of heated area.
Code 41320
Manifold Tag
1 per manifold
Code 46755
Pumpset / Blender unit
1 per manifold
Code 41437
Pipe bends
2 per port (used to form a neat bend in the pipe beneath the manifold)
Code 41050
