AmbiFloat 10

The AmbiFloat 10 system can be used in existing floor constructions as well as new build applications.

For Floating Floors line

The AmbiFloat 10 system can be used in existing floor constructions as well as new build applications.

  • Heat Output up to 80w/m2
  • Incorporates insulation layer
  • Can be used with existing floor constructions
  • ‘Dry’ system – no screed required
Download Spec Sheet
Component Product Code Quantities Required
17mm UFH Pipe Code 41010 6 linnear metres per m2 of heated area
Manifold Code 41320 Depends on heated area - normally approx 1 port per 20m2 of heated area
Manifold Couplings Code 42200 For 17mm Ambiente pipe
Isolating Ball Valves Code 42050 1 pair (sold in pairs) per manifold
Manifold Tag Code 46755 1 per manifold
Pumpset/blender unit Code 41437 1 per manifold
Pipe bends Code 41050 2 per port (used to form a neat bend in the pipe beneath the manifold)
AmbiFloat 10 EPS100 board (25mm) Code 46000 Check drawings to calculate square meterage - 1.2m x 1.2m sheets
50m aluminium foil tape Code 92004 1 roll per 25m2 heated area

The AmbiFloat 10 system can be used in existing floor constructions as well as new build applications. It requires a flat and level solid sub floor for the insulation to fully support the floor finish on top. The insulation is pre-grooved to take the underfloor heating pipework and over laid with foil to assist the distribution of heat.

 

The installation involves covering the complete floor area with insulation and where necessary using battens to provide extra support to door thresholds or perimeter edging. The pipework is then laid into the grooves as per the installation drawings and taken back to the manifold to complete the circuit. The system is then overlaid with a fully floating floor deck onto which your floor finish is applied.

 

In the case of wooden floors, this can be laid directly on to the insulation to minimise height buildup and maximise the heating output. However, please note that you should always check with the wood flooring manufacturer before laying directly onto UFH systems, as some will insist that their products should not come in direct contact with the UFH pipework.

 

In this instance, you would need to lay an additonal layer, such as a 6mm plywood. The reflective properties of the aluminium foil face mean that any heat is efficiently pushed up through the sub-floor layers for maximum heat output. The nature of the system means that it has a quicker response that a traditional (screed) UFH system.