This is a a variant of the AmbiClip system which relies on the heating of the air void to heat the space above it – due to this being the method of heating, the actual output of the system may be limited in some circumstances. Insulation is laid between the battens (25mm minimum) and cliprail sections are laid across the width of the void. Pipework is then run up and down the voids, clipping into the cliprail to keep it consistent. This is a low-cost solution and is ideal in new-build situations where the insulation level is exceptional.

System Overview
  • Heat Output Up to 60w/m2
  • Designed for new-build or refurbishment projects
  • Void Heating system
AmbiVoid Suspended Floors System Datasheet
For more information on the AmbiVoid Suspended Floors system, call 01707 649 118
Product Code Quantities Required Component Images
17mm UFH Pipe 41010 6 linear metres per m2 of heated area
Manifold 41320 Depends on heated area - normally approx 1 port per 20m2 of heated area.
Manifold Couplings 42200 For 17mm Ambiente pipe
Isolating Ball Valves 42050 1 pair (sold in pairs) per manifold
Manifold Tag 46755 1 per manifold
Pipe bends 41050 2 per port (used to form a neat bend in the pipe beneath the manifold)
Pumpset/blender unit 41434 1 per manifold
Cliprails 41450 1 cliprail per m2 of heated area
Cliprail Clips 41505 Approx. 6 clips per m2 of heated area
Border Edge Insulation 41620 1 roll per 50m2 of total floor area

Please note that the above quantities are only guides, and not intended to cover every situation. Factors such as the heat source, heat loss and other parameters will affect the quantities of some products required.

See the AmbiVoid Suspended Floors system in action

Not sure which system would best suit your requirements? No problem, just fill in the basic details below, and one of our team will be in touch to discuss and reccomend the best solution.